EN
- If any irregular operation is detected (e.g., unusual noise or burnt odor from unit), immediately switch it off
and remove the power plug.
- Protect from dust, humidity, sunlight and direct heat radiation.
(*) Authorized service: the after sales department of the manufacturer or importer or other person who is
qualified, approved and competent to carry out this type of repair free of risk. The heater must be handed in to
such a service under all circumstances.
OPERATION
UNPACKING
- Remove heater from carton.
- Remove all protective material which may have been applied to the heater for shipment.
- Check the heater for possible shipping damage. If any damage is found immediately contact the manufacturer.
NOTE:
Save the box and packaging materials for future storage
ASSEMBLY:
A - Handle
B – Washer ø6
C – Locking screw
D – Wheel
E – Axle
F – Washer ø12
G – Matica M12
H – Wheel cover
I – Washer ø12
J – Split pin
K – Openings on the heater
body
- Fix plastic handle with 2 screws and washers.
- Insert the axle into the hole on the heater body.
- Secure the axle by inserting the cotter pins into the appropriate holes.
- Mount the washer and the wheel on both sides of the axle.
- Secure the wheels by screwing the nuts on both ends of the axle.
- Mount the covers on the wheels.
- Attach the handle to the heater body by using the locking screw and washers.
FUELING THE HEATER:
CAUTION!
Never fill the fuel tank indoors. Always fill the tank outdoors. Be sure that the heater is on level ground
when fueling, and never overfill the fuel tank.
-
WARNING!
Never refuel this heater while itis hot or operating. Fire or explosion could result.
- Use only diesel or extra light fuel oil to avoid the risk of fire or explosion. Never use gasoline, other petroleum
products, synthetic solvents, alcohol, or other highly flammable fuels.
- During refueling, monitor all fuel lines and fuel supply connections for leaks. Each leak must be removed before
re-use the heater.
- The fuel gauge on top of the tank allows to check fuel level.