Page 10
23/03/01
The order of assembly from (1) to (13) must be
observed.
Important points:
When assembling the floor insulation (1) as well as
the side jackets (2) care should be taken to ensure they
are in the correct position (with burner cable holes
facing the front).
The water temperature sensors (9) must be pushed
with the pressure spring into the immersion sleeves
(max. 3 per sleeve) and then secured with the
protective guard.
Note: The sensor leads (capillary tubes) should not
be kinked.
The jacket assembly should be in the following order:
1.
Insulation under the boiler both left and right.
2.
Boiler side jackets left and right.
3.
Rear bottom bracing angle.
4.
Front bracing bracket.
5.
Rear inner insulation.
6.
Position burner cable according to door hinging.
7.
Position instrument control panel.
8.
Mount control panel to mounting bracket.
9.
Mount sensors in sensor pockets.
10.
Top jacket.
11.
Outer rear insulation.
12.
Fit insulation retainer.
13.
Fit flue over cast spigot on rear section (using
rubber mallet and block of wood).
ASSEMBLY INSTRUCTIONS FOR: Ca 7s / BCa 7s
