OPERATION
Connect the AC Power Cord to the Power Adapter and plug into an electrical outlet. A Red LED indicator
light will be ON to indicate that the DVR is in Standby mode.
1.
Press the Power button. The POWER LED will turn from red to orange, and other red LED indicators will
turn ON. Note: the system takes approximately 5 to 15 seconds to power up. During the power-up, you will
see the following messages: “HDD Detecting”, followed by “Master HDD Connected”.
Once connected, the POWER LED will change to green color, and red indicator lights be ON next to the
Alarm and Timer buttons.
2.
IF YOU GET THE MESSAGE “HDD NOT FOUND”, PLEASE SEE APPENDIX #1 AS THE
HDD IS LIKELY NOT INSTALLED CORRECTLY.
5
If you purchased a DVR without a hard disk drive, please refer to Appendix #1 for
installation instructions.
Please refer to Appendix #1 for installation / removal of a HDD.
For instructions on connecting your DVR to your Observation System, please refer to
Appendix #2 for various suggested set-ups.
