Warning and Information Labels
Page 4
© Copyright 2021 Stratasys. All rights reserved.
Warning and Information Labels
The following labels appear on the air extraction system.
Preparation
Before installation, check the extraction system for damage. All packaging must be removed
before the system is connected to the power supply.
1. Move the system near the installation location and remove the outer packaging.
Labels
Meaning
Location
Goggles, gloves, and masks must be
worn when handling used filters.
Front of system.
Electrical hazard. Removal of panels
with this label exposes electrical
components.
Back of system
Warning. Turn the power to the system
off before opening the panel with this
label.
Near the cover
release clips.
If the system is used in a manner that is not specified by the manufacturer, the system
warranty is void.
Important:
Read all instructions in this manual before using this system.
• Intended use: This device is intended for indoor use only, to extract and filter
fume from a variety of 3D printers.
• Install this system in a well-ventilated area.
• If you intend to vent the air from the system directly into the room, place the
system at least 50 cm (19.5 in.) from another object on the side of the air outlet
to ensure adequate airflow.
Caution:
Do not cover the exhaust outlets, as this restricts the airflow and causes overheating.
