Stratasys J4100 User Guide
4 Operating and Maintaining the Printer
DOC-26000 Rev. C
4-17
Single Material
Both sections of two print heads are loaded with the same Model material.
Both sections of two print heads are loaded with Support material.
Figure 4-15 One Model material loaded in the print heads
This mode produces parts in Super High Speed mode, at a layer resolution of
55 microns.
5. In the
Required materials
section of the wizard screen, select one or more
replacement materials containers.
6. For Model materials, select
Both
if you need to load two replacement
containers.
Loading one replacement container is more economical because it potentially
requires less flushing of material currently in the system. However, when one
container is not sufficient, loading two containers enables continuous printing
until the print job is completed. When one container empties and the other
one is being used, you can replace the empty container with a new one.
7. For Support material, select
Both
if you need to load two replacement
containers.
❒
In High Speed mode, you can print using one or two Support cartridges.
❒
In Super High Speed mode,
at least
two Support cartridges are required;
you can print with up to four Support cartridges.
8. If the color or mechanical properties of the first printed models are
unimportant, and if you did
not
change the printing mode, you can replace the
Model materials without flushing out the current materials. To do so, continue
with "Changing Model Materials Without Flushing" on page 4-20.
