DT3 CleanStation
DOC-01121 Rev. A
3-14
6.2.2
Cleaning the Manifold
To clean the manifold:
1. Using a 5/16" socket, loosen the hose clamp connecting the manifold to the
hose.
2. Using a 3/8" socket, remove the two 10-32 nuts.
3. Completely remove the pipe clamps and manifold.
4. Remove the material deposits blocking the jets by either pulling it through the
holes, or by flushing the manifold with water.
Figure 6 Cleaning the manifold
6.3 Re-Assembling the Cleaning Station
1. Re-install the manifold and tighten the hose clamp.
2. Re-install the jet plate by sliding it between the washers and the tank.
Note:
Do not over-tighten the nuts.
