18
07.12
Strapex STM 61
6
PREVENTIVE AND CORRECTIVE MAINTENANCE
Fig. 9
Fig. 8
1
2
3
3
1
2
6.1 CLEANING THE TOOL
In the event of severe soiling it is recom-
mended to clean the tool regularly (daily).
The following parts in particular should be kept clean:
– Tension wheel (8/1)
– Toothed plate (8/2)
– Punching tools (8/3)
This is best performed by blowing out with compres-
sed air (wear goggles).
6.2 SETTING THE CUTTING DEPTH
The setting of the cutting depth must corre-
spond to the thickness of the relevant strap.
If set incorrectly, the sealing strength can be reduced.
– Release locknuts (9/1) and (9/2).
– Set adjusting screw (9/3) with screwdriver.
Turning adjusting screw clockwise increases cutting
depth.
Turning adjusting screw counterclockwise
decreases cutting depth.
Set cutting depth so that the lower strap is not tou-
ched during cutting.
– Tighten locknuts.
