STOWE MARINE DATALINE-X COMPASS, User Manual

Page: 36 / 48

Setting-Up Part 4
 
 
Page 30
4.9 Test Mode Entry Screen
The Test Mode will test all display functions (See Part 5 for further details).
1. Press both buttons together, and hold for more than 3 seconds, until
'rEd', 'Grn', or 'YEL' is shown on the display.
2. Press the HEADING button three times, until the LCD shows 'tESt'.
3. Press both buttons together to start to set Test Mode On, the current
value, 'OFF'', will be shown flashing.
4. Select Test Mode On by pressing either button on its own, the LCD
will show 'ON' flashing.
5. Press both buttons together to start Test Mode.
If it is decided not to start Test Mode then press either button to change the
LCD back to flashing 'OFF', then press both buttons to return to showing
'tESt'. Return to the main display by pressing the LOCK button twice to select
the Calibration Mode End Screen, and then pressing both buttons together.
4.10 Shop Demo Mode Setting
The instrument can be set to always power up in demonstration mode by
setting ‘Shop Demo’ Mode On (this function is for use by dealers only).
1. Press both buttons together, and hold for more than 3 seconds, until
'rEd', 'Grn', or 'YEL' is shown on the display.
2. Press the HEADING button twice, until the LCD shows 'SHOP'.
3. Press both buttons together to start to change the Shop Demo mode
setting, the current value, 'OFF' (or 'ON'), will be shown flashing.
4. Select Shop Demo Mode On (or Off) by pressing either button on its
own, the LCD will show 'ON' (or 'OFF') flashing.
5. Press both buttons together to save the Shop Demo Mode setting.
Return to the main display by pressing the LOCK button once to select the
Calibration Mode End Screen, and then pressing both buttons together.
Note: After power up, the instrument will always return from Shop Demo
Mode to showing data if any data is received.
4.11 Leaving Calibration Mode
To return to the main display select the Calibration Mode End Screen.
1. From any Calibration Mode menu screen press either button until
the LCD shows 'End?'. This is the Calibration Mode End Screen.