STOWE MARINE DATALINE-X COMPASS, User Manual, Page: 28 / 48

Setting-Up Part 4
 
 
Page 22
CONTENTS
4.1 System Calibration
4.2 Calibration Mode
4.3 Lighting Colour Selection
4.4 Lighting Bank Selection
4.5 LCD Contrast Setting
4.6 True / Magnetic Headings and Bearings Selection
4.7 Magnetic Variation Entry
4.8 Compass Auto-Deviation Compensation
4.8.1 Compass Auto-Deviation Compensation - With the
Dataline Heading Sensor
4.8.2 Compass Auto-Deviation Compensation - With the
Robertson RFC250 Heading Sensor
4.9 Test Mode Entry Screen
4.10 Shop Demo Mode Setting
4.11 Leaving Calibration Mode
4.1 System Calibration
After installation, the system may be calibrated to take into account the
physical position of and type of transducers installed. Additionally, such
things as display units and precision may be selected.
4.2 Calibration Mode
To enter Calibration Mode:
1. Press both buttons together, and hold for more than 3 seconds, until
'rEd', 'Grn', or 'YEL' is shown on the display.
2. For each successive press of the LOCK button, the display will step
through the calibration menu. To step through backwards, press the
HEADING button.
3. The menu function may be changed immediately by pressing both
buttons together, or this may cause the value to flash, depending on
the function.