To replace an oven light bulb
Switch off the electricity supply to the
appliance at the socket, to avoid the
risk of electric shock.
Wait until the oven is cool, then
remove the oven shelves.
The lens cover on the light can be
removed by grasping the lens cover
and pulling away from the side of the
oven. Unscrew the bulb.
Please note that the oven light bulbs
are not covered by guarantee.
Replacement bulbs can be bought
from any hardware store.
Ventilation
The use of a gas cooking appliance
results in the production of heat and
moisture in the room in which it is
installed. Ensure that the kitchen is well
ventilated; keep natural ventilation holes
open or install a mechanical ventilation
device (mechanical extractor hood).
Prolonged intensive use of the
appliance may call for additional
ventilation, for example opening of a
window, or more effective ventilation,
for example increasing the level of
mechanical ventilation where present.
This appliance is not connected to a
products evacuation device. It shall be
installed and connected in accordance
with current installation regulations.
Particular attention shall be given to
the relevant requirements regarding
ventilation.
Environmental Protection
We are committed to protecting the
environment
and
operate
an
Environmental Management System
which complies with current policy.
Disposal of packaging
•
All our packaging materials are
recyclable and environmentally
friendly.
•
Please help us to protect our
environment by disposing of all
packaging in an environmentally
friendly manner.
•
Please contact your local authority
for the nearest recycling centre.
Caution:
Packaging materials can
pose a risk of suffocation - keep away
from children.
Ready light
The green ready light is located in the
control knob window, below the oven
/ grill indicator dial.
The ready light will come on with a
steady green light to indicate when the
oven / grill has reached a suitable
temperature. For best results, pre-heat
the oven for 15 minutes.
If the green ready light is flashing, or
if the red indicator dial is flashing,
refer to “Micro-computer Operation”
section.
5
INTRODUCTION
