STOVES 1000 RICHMOND CH RAIL MK2, User Manual

Page: 5 / 230

INSTALLATION INSTRUCTIONS
• Assembly and electrical connections must be carried out by specialised personnel.
• Wear protective gloves before proceeding with the installation.
• Electric Connection:
- The appliance has been manufactured as a class II, therefore no earth cable is necessary. The power point
must be easily accessible after the installation of the appliance. If the appliance is equipped with power cord
without plug, a suitably dimensioned omnipolar switch with 3 mm minimum opening between contacts must be
fitted between the appliance and the electricity supply in compliance with the load and current regulations.
- The connection to the mains is carried out as follows:
BROWN = L line
BLUE = N neutral.
• If the hob is electric, gas, or induction, the minimum distance between the same and the lower part of the
hood must be at least 65 cm. If a connection tube composed of two parts is used, the upper part must be
placed outside the lower part.
Do not connect the cooker hood exhaust to the same conductor used to circulate hot air or for evacuating
fumes from other appliances generated by other than an electrical source.
Before proceeding with the assembly operations, remove the anti-grease filter(s) (Fig.1) so that the unit is
easier to handle.
- In the case of assembly of the appliance in the suction version prepare the hole for evacuation of the air.
Fig.1 Fig.2
• We recommend the use of an air exhaust tube which has the same diameter as the air exhaust outlet hole. If
a pipe with a smaller diameter is used, the efficiency of the product may be reduced and its operation may
become noisier.
• If your appliance has been designed for use in habitations supplied with a centralised suction device perform
the following operations:
- The switch controls opening and closure of a valve using a thermo electrical device. By placing the switch in
the ON position, after a minute, the valve opens rotating 90° allowing suction of the stale air. By placing the
switch in the OFF position, the valve closes after 100 seconds.
• Fixing to the wall:
Drill the holes A respecting the distances indicated (Fig.2).
Fix the appliance to the wall and align it in horizontal position to the wall units. When the appliance has been
adjusted, definitely fix the hood using the screws A (Fig.3). For the various installations use screws and screw
anchors suited to the type of wall (e.g. reinforced concrete, plasterboard, etc.).
If the screws and screw anchors are provided with the product, check that they are suitable for the type of wall
EN-4