1.
Lay down the door with the sheet attached and the 740mm
sheet
B
.
2.
Cap the sheets with the 2255mm channels
F
.
3.
Use the door spacers
I
to make sure the door fits the gap
(they sit on top of the “Z” door jambs
L
).
4.
Drill and fix (rivet or screw) the channels at every second rib down
through the top.
5.
Attach the door spacers at each end through the “Z” door jambs
and channels.
6.
Put three fixings underneath through the channels into the
sheeting pan and the top and bottom of the door spacers and “Z”
door jambs (see diagram 1).
7.
Fit the padbolt to the door strap on the outside of the door.
Tips
• To hinge the door on the opposite
side, simply put the top channel on the
bottom and the bottom on the top.
• Put the padbolt on the door before
erecting the panels. It will stop the door
swinging around!
diagram 1
Channels will come short of
the ends of the sheeting by
10-15mm on all panels.
Fix through the top and
bottom of the channels into
the door jamb and spacer.
The door jamb goes on
inside of the channel.
The higher side of the
channel goes to the inside of
the shed. It is very important
to include the fixings on the
underside of all the channels
as they are structural (except
the roof channels).
inside
outside
If you choose to vary from these instructions
your warranty will be impaired.
3
Step 3:
Front wall
I
B
L
N
F
2 x 2255mm “U” channels.
2 x 793mm door spacers.
2 x
1980 x
740mm sheet.
“Z” door jambs (attached to B).
Padbolt
You will need:
I
I
B
N
L
F
If you need advice, call us FREE on 0800 807 433
or email us at [email protected]
spacer
channel
Padlock keeper assembly
keeper
washer
rivet
