Hi-Lift
by
INSTRUCTIONS (CONTINUED)
C.
Continuing from #3 on the preceding page,
pass over one of the double pulleys at #4.
#3
#4
Once over the pulley continue UNDER the "locking
hinge" and through the corresponding hole at #5.
D.
#5
#6
E.
Immediately reverse the rope to pass through the
neighboring hole at #6 and continue UNDER the
"locking hinge" then over the 2nd pulley at #7.
#7
#7
#8
#9
F.
From #7 continue downward to pass through the
second hanging pulley, #8.
G.
After going through the pulley at #8 continue through
the small hole in the mounting bracket at #9.
After passing through #9 finish with a KNOT.
H.
Pull the square brackets down from the ceiling until they are
directly above the object.
i.
Screw the cleat to a nearby wall stud for use as a tie-off point.
Position your boat, SUP, ladder or car carrier beneath the Hi-Lift.
ii.
iii.
Loop the green straps around the object and through the
square brackets. Tighten straps through locking buckles.
iv.
When desired height is reached, force the rope toward the ceiling to
engage locking mechanism. Tie off remaining rope to the wall cleat.
To lower the object, disengage the locking mechanism by pulling the rope down to
vertical. Then allow the rope to feed slowly through your hands, lowering the object.
vi.
vii.
viii.
Using the Hi-Lift
Attach the center "Connecting Strap" to secure pulleys in position.
v.
Grasp the 2 parallel lengths of rope at #5 & #6 and pull to begin
lifting the object.
PRO
