16
17
How to print your designs
Standby Mode:
The PancakeBot will go into Standby mode automatically after
being idle for more than 5 minutes (except if you have pressed the PAUSE button).
To turn back on, simply press the Power Button on the Control Panel.
WARNING:
Do not overfill the Dispenser Bottle or tilt the Dispenser Bottle while it
is connected to the Air Hose and the PancakeBot is turned on. If you see pancake
batter entering the Air Hose, disconnect the Hose from the Gantry and shut
the PancakeBot off immediately. Thoroughly clean and dry the Air Hose before
reconnecting.
How to print your designs
WHILE PRINTING
Adjusting the line thickness using the pressure dial
The pressure dial can be used to adjust the amount of batter dispensed while
printing. The required pressure will vary based on the thickness of the batter being
used - the thicker the batter, the more pressure needed. To increase or decrease
the pressure, rotate the dial on the control panel. Higher numbers indicate higher
pressure within the Dispenser Bottle.
*TIP:
Before printing designs, we recommend that you print a test file with straight
lines to help you adjust the pressure dial and griddle temperature to suit your
batter recipe.
Adjusting the printing speed.
The printing speed of the PancakeBot can be adjusted while the machine is in
operation by selecting the or arrow. Pressing the button each time will
increase the speed by 10% while pressing the button will decrease the speed
by 10%.
NOTE: Speed adjustment only works with PancakeBot 2.0 or the original
PancakeBot with a firmware update.
