Storch 140 HOT, Manual

Page: 103 / 136

103
8.2 Other Faults
Faults Cause Remedy
not ON
Plug not connected to the electrical plug
socket
Put the plug into the electrical socket
Check fuse (see chapter Technical Data)
Pressure too low High pressure nozzle worn out Replace nozzle
Device not running smoo-
thly
High-pressure pump draws in air from an
empty cleaning agent tank
Close the cleaning agent metering valve.
Remove the spray pipe from the spray
gun. Activate the spray gun and allow the
device to run until the air has escaped from
the system and the pump once again runs
smoothly.
No detergent drawn in Detergent tank empty Top up detergent tank
Dirt in detergent tank Clean detergent tank
Suction valve at cleaning agent inlet soiled Remove suction valve and clean or replace
Burner soots up fuel contamination Contact STORCH Service
Burner sooted or adjustment
incorrect
9.1 Recycling the cleaner
If the cleaner is discarded, make it unusable immediately
1.
Unplug the cleaner and cut the power cord. The cleaner contains valuable materials that should be
recycled. Therefore, make use of your local waste disposal site. Contact your local authorities or your
nearest dealer for further information.
Original instruction