12
Changing the sweeping rollers
The sweeping roller consists of two split shells with brushes.
Screws join the split shells.
Dismantling the sweeping roller
To dismantle the sweeping roller, follow the procedure below:
•
Remove the dustbin (see the page 8."Emptying the dustbin").
•
Dismantle the batteries.
•
Press the driving hoop onto the floor till the front of the machine
points upwards.
•
Support the machine securely (for example: second person).
•
Rotate the sweeping rollers till the threaded joints on the
sweeping rollers become visible.
•
Loosen and remove these threaded joints.
•
Remove the sweeping roller split shells from the shaft and if
required, clean the running gear box and the shaft.
Assembling the sweeping roller
The split shells of the sweeping roller have square recesses. These
recesses serve for locating the sweeping roller axis.
•
The two split shells must be put on the rectangular axis of the
brush roller in such a way that the axis fits exactly into the recess
of the split shells.
•
Then, screw each set of brushes with 3 screws each, till you can
no longer see a gap between the split shells.
Setting the traversing mechanism
The traversing mechanism can be readjusted at the adjusting screws
at the handle and at the belt tensioner.
•
Adjust the belt tensioner in such a way that the belt lies loosely on
the handle without tension.
Note
It should be possible to press the belt 4 cm inwards in the
middle till the first resistance is felt.
Summary of Contents for KSE 910
Page 1: ...KSE 910 Date 0507 Operating Manual Battery operated suction sweeper KSE 910...
Page 2: ...2...
Page 18: ...18...
