7
Panel Description
Encoder
Front Panel
4
3
2
1
No
Name
Description
1
Power LED
On: SA-6000E is powered on.
Off: SA-6000E is powered off.
2
Status LED
Solid on: SA-6000E is connected to both an active
video source and SA-6000D.
Blinking: SA-6000E is disconnected from an active
video source. / SA-6000E is disconnected from
SA-6000D.
Off: SA-6000E is powered off or in the boot process.
/ Network is down.
3
Mode
Use this switch to toggle between normal and debug
modes
.
Normal (Default): In this mode, you can connect the
rear panel RS232 port to a RS232 device such as a
computer for bi-directional serial communication
with a RS232 device on the IP control box side.
Debug: In this mode, you can connect the rear
panel RS232 port to a RS232 device such as a
computer for debugging SA-6000E.
4
DIP
This DIP switch consists of four manual switches, which
are used to route audio, video together with IR, and
USB signals between SA-6000E and SA-6000D based
on their positions. By default, each individual switch is in
the up position. For more information, see "Using DIP
Switch to Perform Routing".
Note:
For the DIP switches in both encoder and decoder,
changes to them take effect immediately without
rebooting the system.
