9
ASSEMBLY
UNPACKING
This product requires assembly.
Carefully lift grill and components from the carton and
place the grill on a level work surface.
Inspect the grill carefully to make sure no breakage or
damage occurred during shipping.
Do not discard the packing material until you have
carefully inspected the grill, identified all loose parts, and
satisfactorily operated the grill.
If any parts are damaged or missing, please call
1-800-847-5993 for assistance.
FIREBOX (UPSIDE DOWN)
SUPPORT(S)
BOLTS (CC)
Fig. 5
WARNING:
Do not use this product if any parts on the Loose Parts List
are already assembled to your product when you unpack
it. Parts on this list are not assembled to the product by
the manufacturer and require customer installation. Use
of a product that may have been improperly assembled
could result in serious personal injury.
WARNING:
If any parts are damaged or missing, do not operate
this grill until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
CAUTION:
Some parts may contain sharp edges that may cause
personal injury. Wear protective gloves if necessary.
WASHER
STEP 1: ASSEMBLING SUPPORTS TO THE
FIREBOX
See Figure 5.
Remove the following hardware from the blister pack:
CC
- 3 Round head bolts (M4 x 16 mm) (one per support)
II
- 3 Washers (6 mm) (one per support)
DD
- 6 Self-tapping round head screws (M4 x 12 mm)
NOTE:
The remaining washers will be used in later
assembly steps.
Place the firebox top-down on the floor.
NOTE:
The front of the grill may be located by the screw
holes for attaching the firebox handle.
Insert three supports into the slots on the firebox.
Using bolts (
CC
) and washers (
II
), attach each support
to the firebox. Securely tighten bolts.
