9 — English
FIREBOX
BURNER/BASE
ASSEMBLY
NOTCH
DRAIN HOLE
NOTCHED
CUT OUT
RETAINING
CLIP
CONTROL
KNOB
ASSEMBLY
Fig. 6
STEP 2: RAISING THE TOURIST
™
GRILL
BURNER/BASE ASSEMBLY TO THE
STANDING POSITION
See Figures 6 - 7.
Place burner/base assembly top down on a level surface.
The rear and side legs are spring loaded. While holding
spring loaded leg firmly, release the leg retaining clip on
bottom of the base as shown.
Slowly allow the spring loaded legs to raise to their fully
upright position.
Place burner/base assembly upright on a flat, level non-
combustible surface so it rests on its legs.
Fig. 7
RETAINING CLIP
REAR LEG
REAR LEG
STEP 3: INSTALLING THE FIREBOX AND
HEAT TENT
See Figures 8 - 9.
Hold the firebox over the burner/base assembly with the
notched cut out to the left and the drain hole to the rear.
NOTE:
The control knob is on the front of the firebox.
Ensure that the cut out is not over the control knob or
piezo ignitor.
Align the notches on the bottom of the firebox with the pot
stand on the burner/base assembly and set the firebox
into place.
Attach the three retaining clips on the burner/base as-
sembly over the edge of the firebox as shown.
Fig. 8
LOCATION OF
RETAINING CLIPS
TOP VIEW
