Stoelting A118, Operator'S Manual

Page: 16 / 23

Owner’s Manual #513691 10 A118/D118 Model Machines
B. Remove the lower vented panels on the left and
right side of the machine by pulling the front of
the panel outward to unfasten it from the leg.
Then pull the panel forward to disengage it from
the pins.
B. Press the filter tab and pull the filter out.
C. Visually inspect the condenser filter for dirt.
D. If the filter is dirty, vacuum or brush clean, rinse
with clean water and allow to dry before replacing
on the machine.
NOTE
If the condenser is not kept clean, refrigeration ef-
ficiency is lost.
Water Cooled
The water-cooled condenser is a tube and shell type. The
condenser needs a cool, clean supply of water to properly
cool the machine. Inlet and discharge lines must be 3/8”
I.D. minimum. Make sure the machine is receiving an
unrestricted supply of cold, clean water.
3.13 EXTENDED STORAGE
Refer to the following steps for storage of the machine
over any long period of shutdown time:
A.
Place the CLEAN-OFF-ON switch in the OFF
(middle) position.
B. Disconnect (unplug) from the electrical supply
source.
C. Clean all parts that come in contact with mix
thoroughly with a warm water cleaning solution
Rinse in clean water and dry parts. Do not sanitize.
NOTE
Do not let the cleaning solution stand in the hop-
per or in the freezing cylinder during the shutdown
period.
D. Remove, disassemble and clean the front door,
spigot and auger parts.
E. In a water cooled machine, disconnect the water
lines and drain water. With a flathead screwdriver,
hold the water valve open and use compressed
air to clear the lines of any remaining water.
Figure 3-10 Filter Removal
Press Tab to Remove Filter Press Tab to Remove Filter