Page 13
Due to continuous product research and development,
the information contained herein is subject to change without notice.
www.stoddart.com.au
www.stoddart.co.nz
Installation
Positioning
•
The oven must be installed under an extraction canopy that
meets AS 1668.2.
To allow access to service panel and protection of the control
components, the left hand side of the Combi oven must have
the following minimum clearances:
Service compartment Heat Source
500mm clearance from another heat source, in order to
protect the oven control components and allow access to the
service panel. For distances under 500mm, it is mandatory
for Stoddart heat shields to be fitted (for a minimum distance
of 50mm from the service compartment). Failure to adhere
to minimum clearances may void the oven warranty and add
service costs due to lack of access
Service compartment Non-Heat Source
50mm clearance from a non-heat source to allow access to
the service panel. Any distance under 50mm, may add service
costs due to lack of access
•
Using a spirit level, ensure that the Combi oven is level. Adjust
the foot height to level Combi oven
•
If using a stand, level the stand by adjusting the feet, then level
the Combi oven
IMPORTANT
For stacked ovens refer to the stacking installation manual.
This manual is provided with all stacking kits
WALL
Hea
t Shield
Hea
t Shield
50mm
500mm
500mm
HEAT
SOURCE
HEAT
SOURCE
OVEN
WALL
50mm
50mm
50mm
HEAT
SOURCE
HEAT
SOURCE
OVEN
WALL
50mm
OVEN
50mm
50mm
NON - HEAT
SOURCE
NON - HEAT
SOURCE
