Page 20
Due to continuous product research and development,
the information contained herein is subject to change without notice.
www.stoddart.com.au
www.stoddart.co.nz
Replacing Heat Lamp Bulbs
Gantry Operation
Power
• Heat Lamps can be switched ON or OFF with the GANTRY button on the unit
• Lamps MUST be switched ON when the unit is in operation� Steam from operating as a wet unit and/or steam from foods can pool on
the lamps and damage the wiring
Surfaces
• Nothing should be stored on the top of the gantry
• When operating, the surfaces may be hot� Signage should be displayed for personal and customers to ensure no one will burn
themselves
Rear Sliding Doors
• As glass can be HOT, ensure the rear door slide are OPENED and CLOSED with the glass pulls
IMPORTANT
Where a gantry is fi tted over the bain marie, ensure that the
lamps are always on when operating as a wet unit.
• Bulbs should be allowed to cool for 10 - 15 minutes before removing
• All heat lamp fitting are spring loaded for easy replacement
• Heat lamp bulbs should only be replaced with gloves or a soft cloth� No skin should touch the new bulb� If skin touches the new bulb,
wipe the bulb with a soft cloth and rubbing alcohol to remove all possible oils
1� Isolate from the power supply
2� Squeeze the ends of the lamp shield bars to remove
3� Holding the old bulb with a soft cloth or glove, press into one of the sockets, rotate out and remove
4� Holding the new bulb with a soft cloth or glove, press into one of the sockets, rotate in and slowly release the bulb into the other socket,
ensuring that the bulb does NOT become broken
5� Re-install the lamp shield bars
Bulb
Socket
Lamp Shield Bars
Operation