15
14 VS-2 Control Panel Operation
STANDBY MODE
With both the power and console control cable connected, and all toggle switches in the OFF position, the Fan Jet
will be in standby mode, ready for work. The green LED to the right hand side will pulse slowly indicating power
connection.
NOTE
the current consumed when the Fan Jet is in standby is negligible and these cables can remain connected
overnight or for many days without the vehicle being used with no problems. However, if the vehicle is not to be
used for several weeks, we recommend the power cable is disconnected.
RUN HOLD MODE
Select the required disc speed using the speed dial (
F
) setting 12 giving the maximum disc speed / spread width
Select the required feed motor speed and range to give the correct application rate for your forward speed and
working width.
For calibration instructions see pages 19-20
Switch the feed motor toggle switch X to ON.
The unit is now powered up and enabled.
RUN MODE
Switch the disc ON/OFF toggle switch (
E
) to ON (
I
), both discs will run at the speeds selected. To start product
feeding move the toggle switch
A to start the feed motors, LED # 1 status will now be continuous green.
At headlands to turn both the feed motors OFF, switch the feed motor switch (
B
) to the central position (the discs
remain spinning)
The LED status will be slow pulse red and the audible alarm will sound until switched to ON.
To turn the Left Hand or Right Hand feed motor ON or OFF for border control or short work, move the toggle
switch (
B
) to the appropriate position, the raised position the left hand side is off, lower position the right hand
side is off (remember this is from the driving position of a self-propelled sprayer with the Fan Jets mounted on
the front) The LED status will be slow pulse red and the audible alarm will sound until switched to ON.
In work, if either the feed motor speed or the spinning disc speed is altered from the initial settings, the LED
status will change to rapid pulse red and rapid audible alarm will sound until the original settings are re-selected.
If the speed change is intended to be permanent for the remainder of the field – briefly switch the discs to OFF
for approximately 2 seconds only, until the green LED turns off, then switch the discs back ON and the alarm
status should be cancelled and the green LED should be continuous.
To stop the Fan Jet – switch the disc ON / OFF toggle switch (
E
) to the upper position to power down the machine
and it will return to Standby Mode.
Summary of Contents for Fan Jet Duo Plus VS-2 130
Page 23: ...23 22 Parts drawing...
Page 30: ...30 29 Notes page...
