Warning: Please read directions completely before starting. If you have any
questions, please contact STO N SHO, LLC before beginning your installation. Also,
please check our website (www.stonsho.com
)
for any updates or changes. Thank
You.
Parts Included:
License Plate mounting bracket Assembly. Includes Base Plate and
License Plate Holder.
License Plate Mounting Screws: (4) 6mm X 12mm (Phillips head) and
6mm nuts (10mm wrench size)
Base plate mounting screws: (1) 4.2mm X 35mm screw, 3/16
” spacer,
alcohol pad and 3m tape.
Tools Needed:
7mm and 10mm socket with ratchet Note: 1/4-inch drive referred but 3/8
will work but extra caution will be needed when tightening bolts.
Phillips screwdriver, 7mm and 10mm wrench
Step 1: Ensure all parts listed above are accounted for. Note: If at any time during the
installation process you need assistance please call (408) 776-4080.
Step 2: Separate the license plate holder from the base by simply pulling the pull pin ring
outward and sliding apart.
Step 3: Remove the center screw as shown in figure 1. Using the alcohol pad, clean area where
3m tape will contact body surface. Remove plastic protective film from 3m tape.
Caution: The
3m tape is a one-shot application.
Place the 4.2mm X 35mm screw through the small rear hole.
Then place the 3/16
”
spacer onto the screw. Position the base mount with the pull pin on the
right side as you are looking at the vehicle centered on the hole where the factory screw was
just removed. See figure 2.
Step 4: Using the 4.2 X 35mm screw secure the base plate to the vehicle taking care to align
base plate prior to allowing the 3m tape to contact the body surface.
NOTE: While tightening
the bolt ensure base plate remains square to the vehicle.
See figure 3.
Step 5: Secure the license plate and frame (optional) to the license plate bracket using the
screws and nuts provided. Requires the Phillips screwdriver and 10mm wrench (Not included).
Step 6: Slide the license plate rods into the two tubes located on the base plate. Slide the rods
into the tubes until the rods hit the pull pin. Simply pull the ring on the pull pin and advance the
rods. Release ring and continue to advance rods until the pull pin locks into place.
NOTE: The
Summary of Contents for SNS 297
Page 1: ...Installation Procedures 2019 2022 Mini Cooper S JCW SNS 297...
Page 5: ...Fig 1 Fig 2...
Page 6: ...Fig 3 Fig 4...
Page 7: ...Fig 5...
