Note:
The
BlueNRG-2
device on these boards is clocked at 32 MHz XTAL. These settings are performed in project
configurations.
Figure 1.
Connection between the STEVAL-IDB008V1 or STEVAL-IDB008V2 and PC
RELATED LINKS
4.1 BlueNRG cold start configuration on page 14
1.4
STEVAL-IDB007V1 BlueNRG1 board setup
To connect the
STEVAL-IDB007V1
(
BlueNRG-1
evaluation board) and PC, one USB port is required to provide
power supply to the board. To connect the ST-Link/V2 debugger, an additional USB port is needed.
Note:
Please note that the
BlueNRG-1
on this evaluation board is clocked by 16 MHz XTAL. These settings are
performed in project configurations.
UM2295
STEVAL-IDB007V1 BlueNRG1 board setup
UM2295
-
Rev 1
page 3/35
