STMicroelectronics STEVAL-MKI109V2, User Manual

Page: 28 / 39

4.2.7 Digital output pressure sensors: supported commands
Table 11. Digital output pressure sensors: supported commands list below lists the commands supported by the
devices/demonstration boards including a digital output pressure sensor.
Table 11. Digital output pressure sensors: supported commands list
Command Description Returned value
*setdbXXXVY Selects firmware according to the adapter connected
*start Starts continuous data acquisition (see Table 4. Returned values for *start command )
*debug Returns the output data in readable text format (see Table 5. Returned values for *debug command )
*stop Stops data acquisition
*Zon Forces 3-state
*Zoff Exits from 3-state
*dev Device name e.g.: LIS3DH
*ver Firmware version e.g.: V1.0
*prAA Pressure sensor register read e.g.: PRAAhDDh
*pwAADD Pressure sensor register write
*single It gets a single X, Y, and Z data acquisition (see Table 5. Returned values for *debug command )
*list Prints the list of MKIs supported e.g.: MKI105V1
*listdev Prints the list of devices supported e.g.: LIS3DH
*echoon Activates the write verbose mode e.g.: PRAAhDDh
*echooff Deactivates the write verbose mode
*pfiforst
(1) Pressure sensor “Reset mode” enable st 0 0 0 0 0 0 IR FC FS
*pfifomde
(1)
Pressure sensor “FIFO mode” enable st 0 0 0 0 0 0 IR FC FS
*pfifostr
(1) Pressure sensor “FIFO Stream” enable st 0 0 0 0 0 0 IR FC FS
*pfifostf
(1) Pressure sensor “Stream-to-FIFO” enable st 0 0 0 0 0 0 IR FC FS
*pfifobtf
(1)
Pressure sensor “Bypass-to-FIFO” enable st 0 0 0 0 0 0 IR FC FS
*pfifobts
(1) Pressure sensor “Bypass-to -Stream” enable st 0 0 0 0 0 0 IR FC FS
*pfifodstr
(1) Pressure sensor “Dynamic Stream” enable st 0 0 0 0 0 0 IR FC FS
1. Available only for devices with embedded FIFO.
UM0979
Supported commands
UM0979 - Rev 6
page 28/39