218 Trademark Dr
•
Buda
•
Texas
•
78610
Phone
800.757.2581
•
Fax
844.894.2652
•
3
(c) 2016 SpeedTech Lights, Inc.
Important Points for Your Safety and Longevity of Your Light Bar
- Installers are required to have a good understanding of automotive electronic systems and procedures
for proper installation.
- Never stare directly into the LEDs as momentary blindness and/or eye damage may occur.
- Never take any lights through a car wash. Use only water to clean the outer body/lens of your
equipment.
- Never use a pressure washer to clean any STL products. Inspect and test your product daily to insure it
operates properly and is mounted correctly.
- Never cut wires or work on a unit while the unit is still connected to a power source.
- Never install this product or route any wires through or in the deployment area of the airbag. Doing so
may cause serious personal injury as it will damage or reduce the effectiveness of the airbag by causing
the unit to become a projectile. Reference the owner's manual for your vehicle to find the airbag
deployment area. The User/Installer assumes all responsibility to determine proper mounting location,
based on providing ultimate safety to all passengers in the vehicle.
- If the product requires you to drill holes, the installer must ensure that the drilling process does not
damage any vehicle components or other vital parts. Check all sides of the mounting surface before
beginning to drill. Make sure to deburr all drilled holes and remove any metal remnants or shards to avoid
injury and wires from becoming spliced. Grommets are to be installed in all wire passage holes.
- In order for STL products to operate at optimum efficiency, a secure and good electrical connection to
the battery's Ground Post must be made. The recommended procedure requires the unit's ground wire be
connected directly to the NEGATIVE (-) battery post.
- Instruction manuals should be stored in a safe place for reference if you need to reinstall the unit or
perform maintenance. They can also be found at the main site under the product listing at
www.SpeedTechLights.com. If your product is no longer available on the website contact STL's Customer
Service at 800-757-2581 for assistance.
- If your product requires the use of a control box or remote device to turn on and control your
equipment make sure it is installed in a location that allows both the user and the vehicle to operate
safely in any driving condition.
- Never activate or control your equipment in hazardous driving conditions.
