5
SpeedTech Lights, Inc © 2019
VIRTUE
®
1
DASH LIGHT
Cigarette Lighter Plug Switch Operation (Sold Separately)
On/Off Switch:
•
On Position: Turns on the Light Bar.
•
Off Position: Turns off the Light Bar.
Flash Pattern Button:
•
Cycles to the next flash pattern with each press.
•
Non-Volatile memory recalls the last flash pattern selected.
•
Hold for 3 seconds to toggle Steady Burn mode.
•
Hold for 4 seconds to toggle Random pattern mode.
Extension Cable (Sold Separately)
•
If you have an extension cable with connectors, connect the corresponding ends to
one another. Use the connector at the end of the cable to plug into the control box.
•
If you have an extension cable with one connector, you will need to cut the
connector off of the main cable harness coming out of the Light Bar. Save it as a
spare part. You will solder and heat shrink each wire within the cable harness to
each wire in the extension cable harness. DO NOT cross connect wires. Use the
connector at the end of the extension cable to plug into the control box.
•
If you have an extension cable with no connectors, you will need to cut in the
middle of the main cable harness coming out of the Light Bar. You will solder and
heat shrink each wire within the cable harness to each wire in the extension cable
harness. DO NOT cross connect wires. Use the reattached connector from the end
of the main cable harness to plug into the control box.
•
NOTE: DO NOT leave connectors, cables, solder points exposed to heat, moisture,
or debris.
Flash Pattern Synchronization (Single Color Only)
•
Make sure both units that need to be synced together are powered On and flashing on the same pattern.
•
Connect the White cables of both units to each other.
•
Connect the Yellow cables of both units and c12 VDC to cycle all units to the next pattern.
•
Power all units Off and back On to verify Synchronization is complete.
Dual Color Mode
The Dual Color Virtue-1 has 3 modes: Single Color A, Single Color B, and Dual Color A/B. To cycle color modes, take the White cable
and
c12 VDC.
If you intend to cycle through color modes often, it’s recommended to attach the White cable to a +12 VDC momentary switch.
