K-FORCE® FULL BAR SERIES
SpeedTech Lights, Inc © 2018
3
Wire Color
Function
Wire Color
Function
Light Green
Take Down
Light Blue
Rear Facing Lights
Green
Alley
Purple
Full 360° Warning Lights
Blue
Left Arrow
*Red (Thin)
Control Box In Positive
White
Center Out Arrow
*Black (Thin)
Control Box In Negative
Orange
Right Arrow
*Pink (Thin)
(Standard Model)
Control Box Out Positive
(Super Take Down Model)
Super Take Down
Yellow
Flash Pattern
*Yellow/Green Bengal
(Thin)
Control Box Out Negative
Grey
Cruise Lights (4 Corners)
*Black (Thick)
Negative
Instructions for Mounting, Wiring and Programming
IMPORTANT! To ensure proper installation installers are required to have a good understanding of automotive electronic, systems and proce-
dures for proper installation. When you are drilling into the vehicle’s surfaces, ensure that the area is free of any electrical wires, vehicle uphol-
stery, fuel lines, etc. that could be damaged. All wiring passing through drilled holes should use grommets and silicone sealant to prevent wire
or moisture damage when passing through compartment walls. WARNING! Larger wires and secure or tight connections will ensure longer
service life for your product. It is highly recommended that soldered connections have heat shrink used to protect the connection. Special
attention should be given to the location and method of splicing wiresto make electrical connections to protect these splices from lost power
or connection and corrosion. Insulation displacement connectors are not to be used. To reduce voltage drop, minimize the number of splices in
the wires. The current carrying capacity of wires and fuses will be significantly reduced under high ambient temperature (e.g. under the hood).
Use SXL type wire in the engine compartment where higher heat resistance is required according to SAE J-1128. All wires should be in accor-
dance with the minimum wire size and other recommendations made by the manufacturer and be protected from hot surfaces and moving
parts. Grommets, cable ties, looms, and other installation hardware should be used to anchor and protect all wiring. Fuses should be properly
sized and located as close to the power take off points as possible to protect the wiring and device. To protect against short circuits, a fuse is
included by STL for all products. Do NOT use a fuse with a higher amp rating than the initial fuse included. Do NOT use Circuit Breaks with STL
Products. Ground terminations should only be made directly to the battery.
