11
AFTER SALES SUPPORT
1300 886 649
AUS
MODEL: W60A1A401B PRODUCT CODE: 48662 07/2015
Getting Started (Cont.)
Getting Started (Cont.)
Installation
DANGER!
Make sure your electrical power is disconnected before installing the
dishwasher. Failure to do so can result in death or electric shock.
IMPORTANT!
All relevant pipes and electrical equipment should be installed by
professional plumbers, electricians or dishwasher installers.
Make sure to use new water supply and drain hoses; do not use old
hoses.
IMPORTANT!
Read this manual to familiarise yourself with all parts and operating
principles. Pay particular attention to the safety instructions
regarding installation (page 6).
Unpacking the appliance
• This product has been packaged to protect it against transportation damage.
Unpack the appliance but keep all packaging materials until you have made sure
your new dishwasher is undamaged and in good working order. The carton is
recyclable. Whenever possible, reuse the carton and recycle it when disposing of
the packaging materials.
• Plastic wrapping can be a suffocation hazard for babies and young children,
so ensure all packaging materials are out of their reach. Dispose of any plastic
wrapping safely.
• Unwind the cord to its full length and inspect it for damage. Do not use the
appliance if it or the cord have been damaged during transportation.
In case of
damage, contact our after sales support centre for advice on examination,
repair or return of the damaged product.
Positioning the appliance
• This dishwasher is freestanding. Position it close to an existing water inlet and drain
connection and make sure there is a power point nearby, or in an adjoining cabinet.
The back should rest against the wall behind it and the sides along any adjacent
cabinets or walls. This appliance can also be recessed under a single benchtop.
• The dishwasher’s water supply and drain hoses can be positioned either to the right
or left sides to facilitate proper installation.
• Make sure the appliance does not stand on any water hoses or the power cable.
Levelling the appliance
• Position the dishwasher on a level and sturdy floor. If the floor is uneven, the front
feet of the appliance may be adjusted, just screw the feet in or out a little until it
reaches a horizontal position (the angle of inclination must not exceed 2 degrees).
NOTE: The maximum adjustment height of the feet is 20mm.
Correctly levelled, the appliance will be more stable and much less likely to move or
cause vibrations and noise during operation.
