Getting Started
Assembling the Base
Place the Stand (13) on the Round Base (16), and insert the 4x Base Screws (15) through the
corresponding holes (insert from the top). (Fig.1)
Slide the decorative Stand Cover (14) over the Stand (13) and
place it in the recess on the Round Base (16). (Fig.4)
Carefully place the Stand Assembly upright on the floor.
Remove the Inner Tube (11) from the Stand by first gripping it and then removing the Height
Adjustment Screw (12) fully. (Fig.3)
Partially insert the Inner Tube (11) into the Stand (13), and
hold it in place while re-tightening the Height Adjustment
Screw (12). (Fig.5)
Replace the Motor-Stand Screw (10) and tighten it by hand
so that the Motor section doesn't come off the Stand when
lifted. (Fig.7)
Remove the Motor-Stand Screw (10) from underneath the
Motor Housing (9), then slide the Motor Housing assembly
onto the top of the Inner Tube (11). (Fig.6)
Holding the Base Screws (15) and Round Base (16) in place, tilt up the base to secure from
the underside.
Slide the Base Weight (17) over the 4 Base Screws (15), then secure the Base Weight (17) in
place with the 4x Butterfly Nuts (18). (Fig.2)
Fig.1
Fig.2
Fig.3
Fig.4
Fig.5
Fig.6
Fig.7
8
MODEL: SVS4A-40CR PRODUCT CODE: 51394 12/2015
AFTER SALES SUPPORT
1300 366 155
AUS
