14
MODEL: SUC54EEW | PRODUCT CODE: 62878 | 11/2018
Oven Cooking Guide Cont.
Before first use
• The top surface of the hotplates are sealed with
a heat resistant coating. Before using for the first
time the hotplates should be heated for a short
period without a pan to harden the protective
coating.
• Turn the heat setting to high for approx. 3 minutes
to fully harden the coating. When the hotplates
have cooled apply a thin coating of cooking oil to
the hotplate to seal and protect the surface.
• When a hotplate is on, the hot surface warning
light will come on.
• After switching off, this light will continue to glow
until the temperature of the hotplate drops below
60ºC.
Installation
General Installation Warnings:
• The appliance must be installed by a licensed electrician.
• Please never try to modify or repair the appliance by yourself.
• The appliance should be installed with adequate ventilation.
• A certificate of compliance must be supplied by the Installer and is to be kept by the customer.
• The packing materials must be removed before you install the cooker.
• You must follow the installation instructions in this booklet.
• The surrounding kitchen cabinets must be able to withstand 85ºC.
• The appliance must not be installed in a corner. It must be installed at least 100mm from the side wall.
• Do not obstruct the vents, openings and air spaces on the appliance.
• The anti-tilt plate must be installed to avoid accidental tipping.
• The stabilising bolt must be installed to avoid accidental moving.
• You must not pull or lift the appliance by the door handles.
• A suitable isolating switch providing full disconnection from the mains power supply must be incorporated
in the permanent wiring. The switch must be mounted and positioned to comply with the local wiring rules
and regulations. The isolating switch must be of an approved type and provide a 3 mm air gap contact
separation in all poles (or in all active [phase] conductors if the local wiring rules allow for this variation of
the requirements). The isolating switch will be easily accessible to the customer with the oven installed.
• If the supply cord or cable is damaged, it must be replaced by an approved service agent or a similarly
qualified person in order to avoid a hazard.
• According to the electrical safety regulations, the appliance must be properly earthed.
Connection of the Appliance
Connecting the appropriate power supply (terminal board/connector block):
• Using a screwdriver, prize open tabs of the Terminal board cover.
• Remove the wire clamp screw.
• Fasten the wires beneath the corresponding screw heads, using brass ‘bridge’ for single phase supply.
• Fasten cable clamp and close the cover of the terminal board.
• The AC power supply should be 220-240 V, 50/60 Hz. The minimum 45A fuse, or at least 45A a distribution
circuit breaker.
Solid Hotplates
