12
AFTER SALES SUPPORT
1300 886 649
AUS
MODEL: SORHP1-RH PRODUCT CODE: 49157 05/2015
Fig. 4
Installation (Cont.)
• Drill 4 holes of Ø8mm on the wall, as illustrated below (Fig. 4).
• Hammer the wall plugs into the holes, then insert two ST4x30mm screws
into the lower wall plugs. Tighten the screws, but leave a 2mm gap so
that you can hang the rangehood on the screws in the keyhole slots.
WARNING:
Failure to install the screws or fixing device in accordance
with these instructions may result in electrical hazards!
• Affix the two small L-shaped brackets on the top of the rangehood
housing using the two M4x10mm screws.
• Hang the rangehood (via the keyhole slots on the rear of the rangehood)
on the two ST4x30mm screws in the lower holes and wall plugs. Then
secure the brackets to the wall by screwing the remaining ST4x30mm
screws into the two upper holes and wall plugs (Fig. 5).
WARNING:
Failure to install the screws or fixing device in accordance
with these instructions may result in electrical hazards!
Fig. 5
