1. Place Vac squarely on a stable surface,
such as ground, floor, bench, etc.
2. Remove the Powerhead Assembly of
the Wet/Dry Vac by pulling upward
on the Latches, located on each side
of the Vac. Lift off the Powerhead
Assembly.
3. Dump the Drum contents into the
proper waste disposal container.
Emptying the Drum
Powerhead
Assembly
Latches (2)
PUSH DOWN
PULL OUT
Drum
Drum
Blowing Feature
Your Vac contains a Blowing feature. It
has the capability to blow sawdust and
other debris. It is excellent to use to blow
dust and debris out of garages or off
patios and driveways. Follow the Steps
below to use your Vac as a Blower.
1. Locate Blowing Port of your Vac,
located on the back of the Powerhead
Assembly.
2. Insert one end of the 4 foot x 1-1/4 inch
Hose into the Blowing Port.
3. Turn Vac “ON” and you are ready to
use your Vac as a blower.
WARNING:
To reduce the risk of injury from
accidental starting, unplug power
cord before emptying the drum.
!
CAUTION:
Wear a dust mask if blowing creates
dust which might be inhaled.
CAUTION:
To reduce the risk of hearing damage,
wear ear protectors when using the
Vac/Blower for extended time or in a
noisy area.
WARNING:
Always wear safety eyewear
complying with ANSI Z87.1 (or in
Canada, CSA Z94.3) before using as
a blower.
!
WARNING:
To reduce the risk of injury to
bystanders, keep them clear of
blowing debris.
!
Operation (continued)
!
!
8
Blowing
Port
Hose
SP7068 Stinger_SP7068 2019.indb 8
2/26/19 10:21 AM
