Troubleshooting
Replacement Filter Bag
Problem
Cause
Remedy
Vac will not pick up dirt 1. Clogged Filter 1. Clean or replace Filter Bag
Bag.
(follow instructions on page 10).
2. Clogged Hose. 2. Remove Hose and clear debris.
3. Air leak.
3. Make sure Powerhead is
securely attached to Drum.
Vac will not run
1. No electricity.
1. Make sure electrical outlet has
voltage. (A qualified electrician
may need to be contacted).
WARNING:
If any of the powerhead assembly parts should become detached or broken,
exposing motor or any other electrical components, operation should be
discontinued immediately to avoid personal injury or further damage to the
vacuum. This vacuum has no user serviceable parts.
Cleaning
To keep your Wet/Dry Vac looking its best,
clean the outside with a cloth dampened
with warm water and mild soap.
To clean the Drum:
1. Dump debris out.
2. Wash Drum thoroughly with warm water
and mild soap.
3. Wipe out with dry cloth.
Storage
Before storing your Vac, the Drum should
be emptied and cleaned. The Power Cord
should be wrapped around the unit and
the Hose should be stored as described
in the Power Cord and Hose Storage
Sections in this manual. Accessories
should be kept in the same area as the
Vac so they can be readily available.
The Vac should be stored indoors.
The Power Cord cannot be replaced. If
the Cord is damaged, the Vac should be
destroyed and replaced.
Replacement Filter Bags are available
where you purchased your Vac.
The Stock Number is VF2000.
!
Maintenance (continued)
11
SP7068 Stinger_SP7068 2019.indb 11
2/26/19 10:21 AM
