Page 6 of 9
Fig. 20
Fig. 18
Fig. 21
Fig. 19
31.
Gently pull the kick panel/sill plate toward the brake pedal to release the fasteners securing it.
32.
Connect the ten pin connector of the harness to the amplifier. Slide the red locking tab over to prevent
the connector from accidentally coming disconnected.
33.
Route the harness along the bottom of the front and rear door jam and toward the back seat.
34.
Connect the two pin connector of the amplifier harness to the two pin connector of the subwoofer
harness.
35.
Install the supplied white, three-pin connector by inserting the terminals on the end of the power wire
into the back of the connector until they click and lock. Any wire can go in any hole. Fig. 18
36.
Install the supplied black, two-pin connector by inserting the terminals on the end of the power wire
into the back of the connector until it clicks and locks. Fig. 19
37.
Depress the blue terminal retainer down in the center of the connector.
38.
Remove one of the factory ground nuts on the driver’s side kick area. Connect the two black ground
wires, reinstall the nut and tighten. Fig. 20. Torque to 8Nm.
39.
Connect the green wire of the amplifier harness to the green wire of the subwoofer harness. Then,
connect the brown wire of the amplifier harness to the brown wire of the subwoofer harness. Fig. 21
40.
Run the wire harness along the floor under the rear seats to approximately the middle of the vehicle
and pull the end of the harness under the seat to the cargo area.
41.
Set the subwoofer in place and connect the wire harness.
42.
Rotate the rear seat back until it is nearly vertical. While holding the seat back with one hand, slide the
enclosure back until the hooks on the bracket are centered under the anchor points at the bottom of
the seat. Slowly rotate the seat back toward the rear of the vehicle until it locks into place. Fig. 22
