Page 4 of 9
Fig. 9
A
Fig. 12
12.
Place the amp on top of the bracket by sliding it under the dash past the brake pedal. Make sure the
connecters on the amp are facing toward the fire wall and the mounting holes are facing down.
13.
Using a Torx® T-25 screwdriver install the four supplied screws and washers to attach the amp to the
amp bracket. Fig. 9
14.
Pass the factory radio harness connecter behind the metal framework indicated by the arrow. Fig. 10
15.
Connect the amplifier harness to the amplifier and route the harness up to the radio cavity.
16.
Connect the male radio harness connecter to the female connecter of the amp harness and tuck this
connection into the void between the radio opening and the instrument cluster to avoid interference
with radio during reinstallation.
17.
Route male connector of the amp harness back around the beam as the radio harness originally was.
Fig. 11
18.
You can now connect the radio to the amplifier harness and reconnect the antennae wire and reinstall
the radio.
19.
Remove the two 10mm bolts temporarily installed in step 10. Position the metal plate removed
previously over the top of the amp bracket and secure both with the two 10mm bolts.
20.
Tighten the bottom bolt.
21.
Loosen the four screws indicated by the arrows in Fig. 12 approximately 4 turns.
22.
Remove the screw indicated by arrow A completely. Fig. 12
23.
Install the amplifier with the long tab toward the center of the car. Slide the long tab behind the plastic
and under the lower right screw while pulling out on the plastic. Once tab is completely seated rotate
the amplifier down and secure the short tab in the same manner. Reinstall screw A and retighten the
screws but leave the covers uninstalled. Fig. 13
Fig. 10
Fig. 11
