Still HPT-20, Original Instructions Manual

Page: 47 / 78

If possible, the load should rest on the back of
the fork.
The load must not protrude too far over the
fork tips.
Loads are to be picked up and transported be-
tween the fork arms as close as possible to
the centre.
Taking up load
–
Only place those pallets into stock that do
not exceed the specified maximum dimen-
sions of 1000 x 1200 mm. Damaged load-
ing equipment and improperly designed
loading units may not be used.
–
Attach or secure the load to the load-carry-
ing equipment so that the load cannot move
or fall.
–
Place the loading units into stock so that the
defined aisle width is not reduced by pro-
truding parts.
Transporting pallets
As a rule, loading units (e.g. pallets) are to be
transported individually. Transporting several
loading units at a time is only permissible
●
when instructed by the supervisor and
●
when the technical requirements have been
met.
The operator must ensure proper condition of
the loading unit. Only safely and carefully
positioned loading units may be transported.
Driving on lifts
For this industrial truck, the operator may only
use lifts with a sufficient load capacity and
which the operating company (see
⇒
Chapter
6327_003-009

Operation
5
Handling loads
39 50988046036 EN - 01/2021 - 01