Still CX, Original Instructions Manual

Page: 93 / 156

Operation
5
Using the Digicode control
Using the Digicode control
123 456 789
PRG
PRG
1044_505-007
Digicode control
Access to the electronic control is granted with
three different codes:
• Driver’s code
• master code
• service code
Driver’s code
The driver’s code consists of four digits and
must be created by the Pool Manager.
It is used for the regular utilisation and opera-
tion of the truck by the driver and operator.
The knowledge of the code should be re-
garded as a key and must not be misused.
The driver’s code must not be given to other
persons without express order.
The control can store a maximum of 200
driver’s codes. A driver’s code can be added
⇒ Chapter "Adding a driver’s code", P. 5-89 or
deleted ⇒ Chapter "Deleting a driver’s code
", P. 5-91 with the master code.
Master code
The master code consists of four digits and is
reserved for the Pool Manager.
The factory setting of this code is "1234". The
pool manager is advised to replace this code
with a new master code ⇒ Chapter "Deleting
a master code", P. 5-87 or ⇒ Chapter "Adding
the master code", P. 5-86.
Like the driver’s code, it is used for the regular
operation and use of the truck, but it also
allows the addition or deletion of a driver’s
code. This control can store a maximum of
five master codes.
NOTE
If master codes or driver’s codes are forgotten
or get lost, please contact the Service Engin-
eer, for he alone can make the stored codes
visible.
50108043405 [EN] 85