Stihl RE 150, Instruction Manual

Page: 13 / 28

7.5.2 Removing the spray lance
0000-GXX-4351-A0
2
1
► Squeeze spray lance (1) and spray gun (2)
together and twist as far as they will go.
► Pull spray lance (1) and spray gun (2) apart.
7.6 Attaching and removing the
nozzle
7.6.1 Attaching the nozzle
2
1
0000-GXX-9849-A0
► Push nozzle (1) onto the spray lance (2).
► Twist nozzle (1) until it locks into position.
► If it is difficult to slide the nozzle (1) into the
spray lance: Grease the gasket on the nozzle
(1) with a fitting grease.
7.6.2 Removing the nozzle
2
1
0000-GXX-9850-A0
► Press nozzle (1) and spray lance (2) together
and turn until stop.
► Pull nozzle (1) and spray lance (2) apart.
8 Connecting to a water
source
8.1 Connecting the pressure
washer to the water supply
Connecting the water filter
If the pressure washer is operated with sandy
water or water from cisterns, a water filter must
be connected to the pressure washer. The water
filter filters sand and dirt out of the water and
thus protects the components of the pressure
washer from damage.
Depending on the market, the water filter may be
included with the pressure washer.
2
1
0000-GXX-9869-A0
► Unscrew connector (1).
► Screw water filter (2) onto the water supply
and tighten by hand.
► Screw connector (1) onto water filter (2) and
tighten by hand.
Connecting the water hose
The water hose must meet the following require‐
ments:
–
The water hose has a diameter of 1/2”.
–
The water hose is between 10 m and 25 m
long.
► Connect water hose to a water tap.
► Turn on the water tap fully and rinse the water
hose with water.
Sand and dirt will be rinsed out of the water
hose. The water hose will be vented.
► Turn off water tap.
2
1
0000-GXX-9870-A0
► Push the coupling (1) onto the connector (2).
The coupling (1) audibly engages.
8 Connecting to a water source English
0458-603-0121-B 13