MS 150 TC
English
25
General Information
The carburetor comes from the factory
with a standard setting.
This setting provides an optimum fuel-air
mixture under most operating
conditions.
Preparations
N
Shut off the engine.
N
Check the air filter and clean or
replace if necessary.
N
Check the spark arresting screen
(not in all models, country-specific)
in the muffler and clean or replace if
necessary.
Standard Setting
N
Turn high speed screw (H)
counterclockwise as far as stop (no
more than 3/4 turn).
N
Turn the low speed screw (L)
clockwise as far as stop, then turn it
back 1/4 turn.
Adjusting Idle Speed
N
Carry out the standard setting.
N
Start the engine.
Warm up the engine. Allow engine to
idle for 10 seconds before adjusting the
idle speed.
Engine stops while idling
N
Turn the idle speed screw (LA)
clockwise until the chain begins to
run – then back it off 4 turns.
Saw chain runs while engine is idling
N
Turn the idle speed screw (LA)
counterclockwise until the chain
stops moving – allow engine to run
at idle speed for 10 seconds.
N
Turn the idle speed screw (LA)
clockwise until the chain begins to
run – then back it off 4 turns.
WARNING
If the chain continues moving when the
engine is idling, have your saw checked
and repaired by your servicing dealer.
Erratic idling behavior, poor acceleration
(even though standard setting of low
speed screw is correct)
Idle setting is too lean
N
Turn the low speed screw (L)
carefully counterclockwise, no
further than stop, until the engine
runs smoothly and accelerates well.
It is usually necessary to change the
setting of the idle speed screw (LA) after
every correction to the low speed
screw (L).
Fine Tuning for Operation at High
Altitude
A slight correction of the setting may be
necessary if the engine does not run
satisfactorily:
N
Carry out the standard setting.
N
Warm up the engine.
N
Turn high speed screw (H) slightly
clockwise (leaner) – no further than
stop.
NOTICE
After returning from high altitude, reset
the carburetor to the standard setting.
If the setting is too lean there is a risk of
engine damage due to insufficient
lubrication and overheating.
Adjusting the Carburetor
L
H
3006BA01
1 KN
3006BA025 KN
