FS 410 C-M, FS 460 C-M
English
16
Use the Right Deflector
WARNING
The deflector (1) is approved for brush
knives only and must therefore be
mounted before fitting a brush knife. It is
also necessary to change the guard
ring ((2), see "Mounting the Cutting
Attachment" / "Mounting Mowing
Attachments".
WARNING
Stop (3) is approved for circular saw
blades only and must therefore be
mounted before fitting a circular saw
blade.
Mounting the Deflector
Deflectors (1 and 3) are mounted to the
gearbox in the same way.
N
Remove dirt from joints on gearbox
and deflector – make sure that no
dirt gets into the screw holes in the
gearbox.
N
Place the deflector on the
gearbox (4).
N
Insert the screws (5) and tighten
them down firmly.
Placing power tool on the ground
N
Shut off the engine.
N
Lay your power tool on its back so
that the cutting attachment
mounting face is pointing up.
Fitting the Thrust Plate
N
Slip the thrust plate (1) over the
shaft (2).
Your power tool comes from the factory
with a guard ring (3) for circular saw
blades.
Mounting the Deflector
1
002BA542 KN
2
3
002BA543 KN
4
002BA544 KN
5
Mounting the Cutting
Attachment
002BA406 KN
002BA548 KN
1
4
2
3