![background image](http://html1.mh-extra.com/html/stihl/fc-75/fc-75_user-manual_1378585014.webp)
It is not necessary to disassemble
the complete engine if only the oil
seals have to be replaced.
Clutch side:
- Remove flywheel,
- Lightly tap the oil seal with a
suitable tube or punch to knock
it out of its seat.
•
Fit puller (1) 5910 890 4400
(jaws 0000 893 3706 with profile
No. 3.1).
- Tension legs.
- Pull out oil seal.
Important! The crankshaft stub
must not be damaged.
- Clean the sealing area with com-
mercially available solvent-based
degreasing agent not containing
CFCs or halocarbons,
- Grease sealing lips of oil seal,
- Slide oil seal over crankshaft
stub with open side facing
crankcase.
•
Press it fully home with the press
sleeve (1) 4112 893 2401.
- Fit flywheel,
Starter side:
- Remove starter carrier,
- Lightly tap the oil seal with a
suitable tube or punch to knock it
out of its seat.
•
Fit puller (1) 5910 890 4400
(jaws 0000 893 3706 with profile
No. 3.1).
- Tension legs.
- Pull out oil seal.
Important! The crankshaft stub
must not be damaged.
- Clean the sealing area with com-
mercially available solvent-based
degreasing agent not containing
CFCs or halocarbons,
- Grease sealing lips of oil seal,
•
Slide assembly sleeve (1)
4112 893 2400 over crankshaft
stub.
- Slide oil seal over assembly
sleeve with open side facing
crankcase.
•
Press it fully home with the press
sleeve (1) 1115 893 4600.
- Remove assembly sleeve.
- Fit starter carrier,
1
1
392RA023 VA
1
1
392RA025 VA
1
1
392RA005 VA
1
1
392RA024 VA
1
1
392RA026 VA
14