Stihl BGE 61, Instruction Manual

Page: 24 / 204

5
4
290BA017 KN
► Position the intake screen (3) on the intake
opening.
► Line up the arrows (4).
► Rotate the intake screen (3) in direction of
arrow until the lug (5) engages audibly on the
blower housing.
0000-GXX-2556-A0
Lock button (arrow) must engage in position.
5 Connecting to Power Sup‐
ply
The voltage and frequency of the machine (see
rating plate) must match the voltage and fre‐
quency of the power connection.
The minimum fuse protection of the power con‐
nection must comply with the specifications – see
"Specifications".
The machine must be connected to the power
supply via an earth-leakage circuit breaker to dis‐
connect the power supply if the differential cur‐
rent to earth exceeds 30 mA.
The power connection must correspond to
IEC 60364 and relevant national regulations.
5.1 Extension cord
The design of the extension cord must at least
fulfill the same features as the connecting cord
on the machine. Observe the design marking
(type designation) on the connecting cord.
The cores in the cord must have the following
minimum cross-section depending on the mains
voltage and cord length.
Cord length
Minimum cross-section
220 V – 240 V:
Up to 20 m
1.5 mm
2
20 m to 50 m
2.5 mm 2
100 V – 127 V:
Up to 10 m
AWG 14 / 2.0 mm
2
10 m to 30 m
AWG 12 / 3.5 mm
2
5.2 Strain relief (cord retainer)
The strain relief protects the appliance cord
against damage.
290BA012 KN
2
1
► Insert the plug (1) into the extension cord cou‐
pling (2).
4
290BA013 KN
3
5
► Make a loop in the extension cord.
► Pass the loop (3) through the opening (4).
► Slip the loop over the hook (5) and pull it tight.
5.3 Connecting to Wall Outlet
Make sure your machine is switched off before
you connect it to the power supply – see "Switch‐
ing Off".
► Connect the extension cord plug to a properly
installed wall outlet.
6 Switching On
► Make sure you have a secure and balanced
footing.
► Hold the unit in the normal working position.
English 5 Connecting to Power Supply
24 0458-290-9821-D