11.4
Blow-Sweeping
0000-GXX-4440-A0
► Point the nozzle at the ground.
► Walk slowly and steadily forwards.
12 After Finishing Work
12.1
After Finishing Work
► Switch off the blower, move retaining latch to
position and pull the connecting cable plug
out of the socket.
► If the blower is wet: Allow the blower to dry.
► Clean the blower.
13 Transporting
13.1
Transporting the blower
► Switch off the blower, move retaining latch to
position and pull the connecting cable plug
out of the socket.
Carrying the blower
► Carry blower by the control handle in one
hand.
Transporting the blower in a vehicle
► Secure the blower so that it cannot topple over
and cannot move.
14 Storing
14.1
Storing the Blower
► Switch off the blower, move retaining latch to
position and pull the connecting cable plug
out of the socket.
► Observe the following points when storing the
blower:
–
Blower is out of the reach of children.
–
Blower is clean and dry.
15 Cleaning
15.1
Cleaning the blower
► Switch off the blower, move retaining latch to
position and pull the connecting cable plug
out of the socket.
► Clean blower with a damp cloth.
► Clean vents with a paintbrush.
► Clean the shield with a paintbrush or soft
brush.
16 Maintenance and Repairs
16.1
Maintenance Intervals
The maintenance intervals are dependent on the
environmental and operating conditions. STIHL
recommends the following maintenance inter‐
vals:
Every 12 months
► Have the blower checked by a STIHL servic‐
ing dealer.
16.2
Servicing and Repairing the
Blower
The blower cannot be serviced or repaired by the
user.
► If your blower has a malfunction or is dam‐
aged or requires servicing: Contact your
STIHL servicing dealer.
17 Troubleshooting
17.1
Troubleshooting the Blower and Battery
Condition
LEDs on Bat‐
tery
Cause
Remedy
Blower does not
start when swit‐
ched on
1 LED flashes
green.
Battery has low
charge.
► Recharge the battery fully as described
in the instruction manual for the STIHL
AL 101, 300, 500 chargers.
12 After Finishing Work
English
0458-711-9621-C
25
