Stihl BC 230, Instruction Manual

Page: 9 / 20

1
7
5
8
8 7
6
0000-GXX-6434-A0
► Push the control handle (6) onto the handle‐
bar (1).
► Push the crossbar (5) onto the handlebar (1)
so that the holes are in alignment.
► Fit the screws (7) in the holes.
► Fit and tighten down the nuts (8) firmly.
12
13
1
11
6 9 10
0000-GXX-6454-A0
► Line up the control handle (6), throttle trigger
lockout (9) pointing vertically upwards, so that
it is parallel to the assist handle (10).
► Insert and tighten down the screws (11) firmly.
► Secure throttle cable (12) to handlebar (1) with
two cable ties (13).
The assist and control handles do not need to be
removed again.
6.2 Fitting and Removing the
Wheels
6.2.1 Mounting the Wheels
► Shut off the engine.
1
4
5
2
3
0000-GXX-6437-A0
► Align the wheels (1) so that the cultivator spur
(2) points in direction of the engine and the
lowest hole in the spur (2) lines up with the
hole in the bracket (3).
► Fit the pin (5) through the hole in the bracket
(3).
► Fit the cotter pin (4) in the hole in the pin (5).
The pin (5) is now secure.
6.2.2 Removing the Wheels
► Shut off the engine.
1
4
5
2
3
4 1 5
0000-GXX-6444-A0
► Pull out the cotter pin (4).
► Remove the pin (5).
► Lift away the wheels (1).
► Fit the pin (5) through a hole in the bracket (1).
► Fit the cotter pin (4) in the hole in the pin (5).
The pin (5) is now secure.
6.3 Fitting and Removing the
Blades
6.3.1 Mounting the Rotor Blades
A video is available for this chapter
www.stihl.com/sxLLXe
► Shut off the engine.
3 1
1
2
2
0000-GXX-6435-A0
► Pull out the cotter pins (2).
► Push the blades (1) onto the output shaft (3).
► Fit the cotter pins (2) through the holes in the
output shaft (3).
The blades (1) are secure.
6.3.2 Removing the Rotor Blades
► Shut off the engine.
► Pull out the cotter pins.
► Remove the blades.
► Fit the cotter pins through the holes in the out‐
put shaft.
The cotter pins are secure.
6 Assembling the Cultivator English
0458-495-0121-B 9