Technical Information 08.2005
Page 19
TI_08_2005_11_01_02.fm
.
Run the arrester (
1
) through the pleated hose
(
7
) and hose clip (
9
) (hose clip with the retention
groove for the throttle cable) – screw head and
retention groove facing forward.
.
Shove the hose clip (
9
) onto the pleated
hose (
7
).
.
Hook the discharge wire hook (
1
) in the
loop (
10
).
.
Shove the pleated hose (
7
) with the hose clip (
9
)
in the shown position over the manifold (
11
).
.
Tighten down the screw (
12
).
.
Shove nozzle (
13
) (depending on the market
region) onto blower tube (
2
), and lock the
buttons (
14
).
Only operate the device when the arrester is
correctly mounted.
Check the following:
.
The hook on the arrester is always in the loop
(
arrow
)
.
The sleeve on the arrester is always clipped in
the holder (
arrow
)