WORKSHOP MANUAL
ZT 5132 T
Chapter
5 - STEERING SYSTEM - TRANSMISSION - WHEELS
EDITION
2017
PAGE
30 /
58
5.3.3 Replacing the front wheels pin bearings
• Remove the front wheel
[
1. Remove the top cover (1) and undo the screw
(2) to slide the fork (3) out of the hub (4).
2. Remove the bearings (5) by
hitting it from the inside of the
hub with a round bar 12 ÷ 15
mm in diameter.
IMPORTANT
We recommend
you always replace both hub
bearings.
On reassembly, make sure the two shim washers (6) are positioned correctly.
Tighten the screw (2) to a torque of 124 Nm.
5.3.4 Replacement and repair of tyres
The tyres used on this machine are of the «Tubeless» type and so every repair of a hole in the tyre
must be done by a tyre specialist according to the methods used for this type of tyre.
IMPORTANT
The rear tyres can have different rolling diameters, due to wear or after replacement
of one of the two. These differences must never be offset by varying the inflation pressure, which
must ALWAYS be the same for both.
After the replacement of one or both tyres, it is always necessary to:
• check the tyre pressure
[
;
• check the height of the blades from the ground
[
5
6
5
5
6
2
1
4
3