Stiga ZT 5132 T, Workshop Manual

Page: 29 / 58

WORKSHOP MANUAL
ZT 5132 T
Chapter
5 - STEERING SYSTEM - TRANSMISSION - WHEELS
EDITION
2017
PAGE
29 /
58
5.3 WHEELS AND TYRES
5.3.1 Removing and replacing the rear wheels
• Lift the rear part of the machine [ 2.3.3].
The rear wheels (1) are fixed to the hydrostatic
unit shaft by a screw (2).
NOTE If a wheel is jammed onto the shaft, use a
release spray directing it around the press-fitting
hole .
WARNING! - ALWAYS replace deformed
rims as they could impair the hold of the tyre.
On assembly it is advisable to spread grease on the shaft to facilitate the next wheel removal.
Tighten the screw (2) to a torque of 65-98 Nm.
5.3.2 Replacing the front wheels
• Lift the front part of the machine [ 2.3.2].
Undo the screw (1) and remove the wheel (2)
from the support fork (3).
NOTE The replacement wheel is available to-
gether with the tyre and to the bearings.
On reassembling, make sure that the spacer 4) is
positioned correctly and grease the bearings us-
ing the designated greaser device (5).
Tighten the screw (1) to a torque of 124 Nm.
1
2
5
4
1
2
3