WORKSHOP MANUAL
ZT 5132 T
Chapter
2 - SERVICING RECOMMENDATIONS
EDITION
2017
PAGE
10 /
58
Special tightening torques are indicated in the manual in the description of the specific proce-
dures.
2.3 TRANSPORTATION AND HANDLING
2.3.1 Machine transportation
Pay utmost attention when loading the machine on or off a trailer or truck.
• Use the machine chassis to fasten it to the means of transport
• NEVER fasten it to bars or joints that could get damaged.
• DO NOT transport the machine with the equipment (if any) in the raised position.
2.3.2 Front lifting
Engage the parking brake to block the rear wheels and
prevent any uncontrolled movement of the machine.
Position a jack (1) under the front end of the footplate
(2) and lift it enough to insert two stands (3) under the
support arm (4) on the front wheels.
Release the jack and make sure the machine is
stable before starting any work.
2.3.3 Rear lifting
Position two suitably sized wedges in front of the front
wheels to prevent all uncontrolled movement of the
machine.
Position a jack (1) in the centre of the rear beam of the
chassis (2) and lift it enough to insert two stands (3) on
both sides of the chassis.
Release the jack and make sure the machine is
stable before starting any work.
Hexagonal head screws and nuts
UNC Thread Ø
1/4-20
5/16-18
3/8-16
7/16-14
1/2-13
Key
7/16"
1/2"
9/16"
5/8"
3/4"
Torque (grade 2) Nm
7
15
27
40
69
Torque (grade 8) Nm
16
35
62
97
152
Hexagonal Allen grub screws
UNC Thread Ø
1/4-20
5/16-18
3/8-16
7/16-14
1/2-13
Key
3/16"
1/4"
5/16"
3/8"
3/8"
Torque (grade 2) Nm
7
15
27
40
69
Torque (grade 8) Nm
16
35
62
97
152
1
3
2
4
1
2
3
4
